Fitting The Line Connections - Steinbach Classic 250N Originalbetriebsanleitung

12. Align the valve head so that the "PUMP" connection points towards the future position of the pump
(see Fig. in the section "Mounting the pump on the base plate").
13. Place the locking ring
8
14. Insert the screws of the locking ring and tighten them clockwise.
15. Remove the bleeder screw
head by turning it counter-clockwise.
16. Wrap the manometer thread
tape .
15
17. Screw in the manometer at the removal
position of the bleeder screw by turning it
clockwise.
The filter vessel is prepared.

Fitting the line connections

Some hoses, such as the pressure hose, are very stiff. Place them in the sun before use
so that the heat makes them more flexible.
Use suitable pool hoses Ø 32 / 38 mm for the described connections. Other pool hoses (such as INTEX
with threaded connection) require additional adapters. For the matching adapters, visit our web shop at:
www.steinbach-group.com
To connect a swimming pool hose to the pump
or filter vessel, proceed as follows:
1. Guide a hose clamp over the hose.
2. Push the hose onto the hose connection.
3. Fix the hose clamp on the hose connection
using a Phillips screwdriver PH1.
The swimming pool hose is connected.
around the valve head and filter vessel connecting point.
5
9
on the valve
18
with Teflon
13
10
11
29