Heiniger Xpert/C Originalbetriebsanleitung Seite 35

Malfunction
Motor does not run or stops
immediately.
Shearing machine cuts badly
or not at all.
Motor unit becomes hot.
Translation of the original instructions / Sheep shearing machine Xpert
Cause
Clipping pressure too strong. Reduce the clipping
Smell of burning from the
motor housing. Motor burned
out.
Motor and/or electronics
defective.
Motor turns off due to
overload.
shearing blade is blunt.
shearing blades have not
been correctly ground.
Clipping pressure too low.
Shearing blade is incorrectly
installed and/or aligned.
The animal's hair is wet.
Hairs stuck between upper
and lower blade.
Air filter clogged.
Clipping pressure too high.
Bearing faulty.
Rectification
pressure, as described in
chapter 6.2. Have the blades
sharpened.
Notify customer service.
Turn off the device, allow it
to cool down and then turn
it on again. Notify customer
service if the device is not
working properly.
Notify customer service.
Increase the clipping
pressure as described in
chapter 6.2.
Correctly install the shearing
head, as described in
chapter 6.5. Align the
shearing blades correctly,
see Fig. 10.
Only shear dry hair.
Remove the shearing blades;
clean, lubricate and install
them again; set the clipping
pressure.
Clean or replace the air filter.
Reduce the clipping
pressure.
Notify customer service.
17