Control Panel - Panasonic EY7440 Bedienungsanleitung

How to Use the Belt Hook
WARNING!
• Be sure to attach the belt hook
securely to the main unit with the
screw firmly fastened. When the belt
hook is not firmly attached to the main
unit, the hook may disconnect and the
main unit may fall.
This may result in an accident or
injury.
• Periodically check screw for tight-
ness. If found to be loose, tighten
firmly.
• Be sure to attach the belt hook firmly
and securely onto a waist belt or other
belt. Pay attention that the unit does not
slip off the belt. This may result in an
accident or injury.
• When the main unit is held by the
belt hook, avoid jumping or running
with it. Doing so may cause the hook
to slip and the main unit may fall.
This may result in an accident or
injury.
• When the belt hook is not used, be
sure to return it to the storing posi-
tion. The belt hook may catch on
something.
This may result in an accident or
injury.
• When the unit is hooked onto the
waist belt by the belt hook, do not
attach driver bits to the unit. A sharp
edge object, such as a drill bit, may
cause injury or an accident.
To Set the Belt Hook Angle
Position
1. Slide the belt hook lock lever 1 and
hold it to unlock the belt hook.
. P u l l t h e b e l t h o o k
from storing position
2 and set it.
3. Release the belt hook
lock lever to lock the
angle of belt hook.
4. Make sure the belt hook is firmly
locked. Also make sure the belt hook
is firmly locked into position 3.
• The belt hook can-
not be locked in this
position. Firmly lock
it into position before
use.
To return the belt hook to the storing
position, follow step 1. and . above,
then lower the belt hook.
To secure the lock, follow 3 and 4
above.
To Change the Belt Hook
Location Side

Control Panel

(1) LED light
2
1
3
- 8 -
The belt hook can be attached to
either side of the unit.
1. Set the belt hook at storing posi-
tion.
. Loosen the screw turning it coun-
ter-clockwise, using a flat metal or
a flat blade screw driver.
3. Take out the belt hook and insert
into the other side of the slot on the
main unit.
4. Fasten the screw firmly, turning it
clockwise.
The belt hook can be taken out from
the main unit only when it is at storing
position.
(1)
Pressing
LED light on and off.
The light illuminates with
very low current, and it
does not adversely affect
the performance of the
driver during use or its bat-
tery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
(3)
()
toggles the