Before Starting The Equipment; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GP-EA 18/150 Li BL-Solo Originalbetriebsanleitung

5. Before starting the equipment

5.1 Charging the Li battery pack (Fig. 2-3)
1. Remove the battery pack (a) from the handle,
pressing the pushlock button (b) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(c) into the socket outlet. The green LED will
then begin to blink.
3. Push the battery pack onto the battery char-
ger.
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger
•
and the battery pack
to our customer service center.
5.2 Battery capacity indicator (Fig. 2/Item e)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (e) will indicate
the charge status of the battery by means of 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Anl_GE_EA_18_150_Li_BL_SPK13.indb 16 Anl_GE_EA_18_150_Li_BL_SPK13.indb 16
GB
5.3. Fitting the stirrer/auger screw
To avoid the machine starting up unexpectedly,
remove the battery before you fi t the stirrer/auger
screw.
Fitting the stirrer and adapter (Fig. 4a-4b)
Fitting the stirrer/auger screw/extension (Fig. 5a-
5c)
6. Operation
6.1 On/Off switch (Fig. 6/Item 1)
Always use both hands to hold the powered
equipment by its handles. Grip the handles fi rmly
with your thumbs, with your right hand on the ope-
rating handle.
Switching on:
Press the safety lock-off (3) and the On/Off switch
(1).
Switching off :
Release the On/Off switch (1).
6.2 Switch settings/direction of rotation (Fig.
1a/Item 2)
A. Clockwise setting 1
B. Clockwise setting 2
C. Counter-clockwise
6.3 Changing the blades (Fig. 5d/Item A) on
the auger screw 120mm and 150mm
Change the blades as shown in Fig. 5d.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
- 16 -
04.06.2021 10:39:02 04.06.2021 10:39:02