Remote On-Off - CLIVET CEILING & FLOOR 2 IF3-XY 53M Handbuch Für Installation

Installation
INDOOR unit terminal block
Morsettiera unità INTERNA
L
power supply
alimentazione
from the OUTDOOR unit
dalla morsettiera
terminal block
dell'unità ESTERNA
Magnetic ring
Pass the strap through the
hole in the magnetic ring
to secure it to the cable

REMOTE ON-OFF

For the input of the remote control terminal CN23
(ON-OFF) and the JR6 quick-release connector
– Remove the JR6 quick-release connector when
using the ON-OFF function;
N S
signal
segnale
Fig. 26
1 2 3
Fig. 27
Fig. 28
– When the remote switch is OFF (OPEN), the unit
will be turned off;
– When the remote switch is ON (CLOSE), the unit
will be turned on;
– When the remote switch is opened/closed, the unit
will respond to the request within 2 seconds;
– When the remote switch is ON, the remote/wired
control can be used to select the mode; when the
remote switch is OFF, the unit will not respond to
the remote/wired control request.
When the remote switch is OFF, the remote/wired
control is on, code CP will be shown on the display
board.
– The input voltage is 12 V DC, the maximum design
current is 5 mA.
21