Installation; Safety Instructions For Installation - Weh TW54 Betriebsanleitung

AE Operating instructions

7. INSTALLATION

7�1

Safety instructions for installation

Î Check the information provided in these operating instructions and the label on the
WEH Product. The information must conform to your application.
®
Î Only connect the WEH
Î Check the WEH
you should detect anything wrong with the WEH
Replace the WEH
Î Remove transport securing devices (such as protection caps) before installing the
WEH Product. Transport securing devices serve the purpose of protecting the
®
product and connection ports during transport and storage. The transport securing
devices are not, for example, designed to withstand pressure or to be used as plugs.
Î Ensure that the system is depressurized. Installation must only be effected in
depressurized condition.
Î
Avoid using excessively short media hose lines and narrow bending radii. Lateral
forces may cause leakages or damage to components and make it more difficult to
attach the WEH
Î
Use arrestor cables, partitions, etc. for additional safety where being used for
hazardous applications or under hazardous conditions.
Î
Before installation, check if the counterparts are designed to withstand the assembly
data (see Chapter 7.2 Installing the media hose line) that WEH determined for this
WEH Product.
®
Note: The assembly data (torques, assembly turns etc.) are values which apply
exclusively to the components delivered by WEH.
Î
Position the WEH
(pos. 3) is visible. This must be visible for the operator.
Page 16
MD-10017-L51-R2.1.0-03
Product to faultless connections.
®
Product for transport damages, contamination and other damage. If
®
Product or send it to WEH for maintenance.
®
Connector properly.
®
Product in your system so that the red marking on the front part
®
Product, it may no longer be used.
®