Comprag RECOM RCW-Serie Bedienungsanleitung Seite 8

equipment. Immediately disconnect it from the power supply. Do not open the doors of equip-
ment until the temperature falls to room temperature, in order to prevent burns or injury.
12. Naked flames must not be used as a light source for inspecting and checking equipment.
13. Never use caustic solvents, which may damage materials of the pneumatic system.
14. After performing installation or other work, ensure that no instruments, rags or spare
parts have been left inside the equipment.
15. Pay particular attention to the safety-relief valves. Thoroughly inspect them and remove
any dust and dirt. They must not be allowed to suffer any loss in function under any circum-
stances. Remember that your safety depends on their functionality!
16. Before beginning work in normal mode after maintenance or repair work, check that the
working pressure, temperature and other characteristics are correctly set. Ensure that all
control devices are installed and functioning properly.17. When replacing filters, separators
etc., wipe away dust, dirt and oil residue from the area where they are installed with a dry
cloth.
18. Protect the motor, air filter, electrical components and control components etc. from com-
ing into contact with condensate. For instance, blow down with dry air.
19. Safety precautions for operation with refrigerants:
• Never inhale refrigerant vapours. Ensure that the work zone is properly ventilated;
use a respirator if necessary.
•Always wear special-purpose gloves. If the refrigerant comes into contact with skin,
rinse the area of contact with plenty of water. If refrigerant comes into contact with
skin through clothing, do not try to remove clothing. Thoroughly rinse clothing with
fresh water until the refrigerant is washed off. Then seek medical assistance.
20. Use protective gloves during installation and repair work in order to avoid burns and injury
(for instance, during oil change).
8
Version 2.3