AEG SCE81911TS Benutzerinformation Seite 31

8.1 What to do if...
Problem
The appliance does not op-
erate.
Audible or visual alarm is on. The cabinet has been re-
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC" or "COOLMATIC", or af-
ter changing the tempera-
ture.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
cently switched on or the
temperature is too high.
The temperature in the ap-
pliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "FROSTMATIC" or
"COOLMATIC" is switch-
ed on.
This is normal, no error has
occurred.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Refer to "High temperature
alarm".
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
The compressor starts after a
period of time.
31