Functions Menu; Temperature Regulation; High Temperature Alarm; Coolmatic Function - AEG SCE81911TS Benutzerinformation

1. • The Fridge compartment
indicator is on.
• The display indicates the latest
set temperature for the fridge.
2. • The Freezer compartment
indicator is on (In normal
conditions).
• The display indicates the latest
set temperature for the freezer.

4.7 Functions menu

Each time MODE is pressed, the
following functions are activated in a
clockwise direction:
• FROSTMATIC function

• COOLMATIC function

• DYNAMICAIR function
• no symbol: normal operation.
You can set one function ON
at any time and set the
function OFF by pressing
MODE several times until no
icon appears.

4.8 Temperature regulation

The temperature within the appliance is
controlled by the Temperature regulator.
The temperature of the fridge
compartment may be regulated by
rotating the Fridge temperature
regulator, and may vary between more or
less +2°C and +8°C.
The temperature of the freezer
compartment may be regulated by
rotating the Freezer temperature
regulator, and may vary between more or
less -15°C and -24°C.
For a correct storage of the food the
following temperatures should be set:
• fridge: +5°C
• freezer: -18°C
During normal operating the
Temperature indicator shows the
temperature currently set.
To operate the appliance proceed as
follows:
1. turn the Temperature regulator
clockwise to obtain the maximum
coldness.
2. turn the Temperature regulator
counter - clockwise to obtain the
minimum coldness.
The intermediate position is
usually the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature
inside the appliance
depends on:
• room temperature
• how often the door is
opened
• the quantity of food
stored
• the location of the
appliance.

4.9 High temperature alarm

An increase in the temperature in the
freezer compartment (for example due to
a power failure) is indicated by:
• flashing temperature
• freezer compartment flashing (Freezer
compartment indicator)
• sounding of buzzer
• red illumination of display
When normal conditions are restored:
• the acoustic signal shuts off
• the temperature value continues to
flash
• the display illumination remains red.
When you press MODE / Alarm reset
switch to deactivate the alarm, the
highest temperature reached in the
compartment appears on indicator
for few seconds.
At this point the flashing stops and the
display illumination changes over from
red to white.
During the alarm, the buzzer can be
switched off by pressing MODE / Alarm
reset switch.
The illumination of the display remains
red until normal storage conditions are
restored.
4.10 COOLMATIC function
If you need to insert a large amount of
warm food, for example after doing the
ENGLISH 25