DeWalt dc228 Handbuch Seite 40

E N G L I S H
• Depending on your tool, follow either of the
following instructions:
- Fit a chuck adaptor/chuck assembly (DC228/
DC232). Special SDS-plus adaptors with
threaded sections are available for use with
standard 10 or 13 mm chucks to enable
straight shank bits to be used.
- Replace the tool holder with the chuck
(DC229/DC234).
• Proceed as described for hammer drilling.
CAUTION: Never use standard chucks
in the hammer drilling mode.
Screwdriving (fi g. A)
• Set the mode selector switch (3) to the "rotary
drilling" position.
• Select the direction of rotation.
• Depending on your tool, follow either of the
following instructions:
- Insert the special SDS-plus
adaptor for use with hexagonal screwdriver bits
(DC228/DC232).
- Replace the tool holder with the chuck
(DC229/DC234).
• Insert the appropriate screwdriver bit. When
driving slotted head screws always use bits with
a fi nder sleeve.
• Gently press the variable speed switch (1) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
• When the screw is fl ush with the workpiece,
release the variable speed switch to prevent the
screw head from penetrating into the workpiece.
DC229/DC234 - Chipping (fi g. A)
• Set the mode selector switch (3) to the
"hammering only" position.
• Insert the appropriate chisel and check if it is
properly locked.
• Adjust the side handle (9) as required.
• Switch on the tool and start working.
It may be necessary to briefl y run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
38
Optional accessories
Various types of SDS-plus
are available as an option.
®
screwdriving
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• This machine is not user-serviceable. Take the
tool to an authorised D e WALT repair agent after
approximately 40 hours of use. If problems
occur before this time contact an authorised
D e WALT repair agent.
Lubrication
Your power tool requires no additional lubrication.
Accessories and attachments used must be
regularly lubricated around the SDS-plus® fi tment.
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fl uids
(benzine, alcohol, etc.).
• Do not mix or stir infl ammable liquids
labelled accordingly.
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
® drill bits and chisels
WALT power tool has been designed to
E
WALT, have
E