Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Replace defective light source and reassemble
properly in reverse order.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the hinge cover as described under
versing the door opening"
upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
"Re-
and disassemble the

Troubleshooting

Before you contact an authorized specialist
Problem / cause / action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
- Check the temperature setting / the condensa-
tion drip tray.
Light does not work
- Check the power supply.
"Changing the light"
- See
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
25
.
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis