Troubleshooting - BOMANN KS 2184.1 inox look Bedienungsanleitung, Garantie

Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator, it can be damaged.
 During the defrosting process in the fridge, the
water drops drain off at the back wall of the cooling
chamber. The thaw water running through a channel,
is collected in a drip tray located on the compressor,
from which it then evaporates. Make sure that the
defrost water drain channel does not become
clogged. A slight formation of ice on the interior rear
wall during operation is normal.
A permanently high power level can lead to in-
→ set a lower power level and
creased ice formation
wipe the interior of the appliance dry.
 To achieve better cooling and to save energy,
defrost the freezer regularly:
• To start the defrosting process, disconnect the
appliance from the power supply.
• Remove the appliance content and keep covered
at a cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the light
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the appliance top cover as described
"Reversing the door opening"
under
semble the upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately

Troubleshooting

Before you contact an authorized specialist
Problem / Cause / Action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
28
and disas-