Residual Risks - DeWalt DC352 Anleitung

EN GLI SH
Additional safety instructions for all
saws with riving knife
a) Use the appropriate riving knife for the blade
being used. For the riving knife to work, it must
be thicker than the body of the blade but thinner
than the tooth set of the blade.
b) Adjust the riving knife as described in
this instruction manual. Incorrect spacing,
positioning and alignment can make the riving
knife ineffective in preventing kickback.
c) For the riving knife to work, it must be
engaged in the workpiece. The riving knife is
ineffective in preventing kickback during short
cuts.
d) Do not operate the saw if riving knife is bent.
Even a light interference can slow the closing
rate of a guard.
Additional safety instructions for
plunge-type saws
• Wear ear protectors. Exposure to noise can
cause hearing loss.
• Wear a dust mask. Exposure to dust particles
can cause breathing difficulty and possible
injury.
• Do not use blades of larger or smaller
diameter than recommended. For the proper
blade rating refer to the technical data. Use only
the blades specified in this manual, complying
with EN 847-1.
• Never use abrasive cut-off wheels.

Residual risks

• In spite of the application of the relevant
safety regulations and the implementation of
safety devices, certain residual risks cannot be
avoided.
These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered
parts of the rotating cutting disc.
– Risk of injury when changing the disc.
– Risk of dust inhalation from materials that
when cut, can be harmful.
Labels on tool
The following pictogram is shown on the tool:
Blade diameter
34
Additional safety instructions for
battery packs
WARNING: Fire hazard! Avoid metal
short circuiting the contacts of a
detached battery pack. Do not store
or carry the battery pack without the
battery cap placed over the contacts.
• The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful. If
electrolyte liquid comes in contact with skin,
immediately wash with soap and water for
several minutes. In case of eye contact, rinse
abundantly with clean water for at least
10 minutes. Consult a physician.
• Never attempt to open a battery pack for
any reason.
Additional safety instructions for
battery packs and chargers
• Make sure that the battery pack is dry and
clean before inserting it into the charger.
• Use only chargers labelled "NiMH" or "NiMH +
NiCd" to charge D WALT NiMH battery packs.
E
• Never carry the charger by its cord. Never pull
the cord to disconnect from the socket. Keep
the cord away from heat, oil and sharp edges.
• Do not expose the charger to damp or wet
conditions.
• Do not attempt to charge wet battery packs.
• Never attempt to open a battery pack for any
reason.
• Always follow the instructions in the back of this
manual for battery pack disposal.
• When not in use, chargers and battery packs
must be stored in a dry place and locked up
securely, out of reach of children.
STORAGE RECOMMENDATIONS
1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold.
2. Long storage will not harm the battery pack or
charger. Under proper conditions, they can be
stored for 5 years or more.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual
before use.