Optional Accessories - DeWalt DC352 Anleitung

The guide clearance of the plunge saw must be very
small for best cutting results and can be set with the
two rail adjusters (j).
1. Release the screw inside the rail adjuster to
adjust the clearance.
2. Adjust the knob until saw locks on rail.
3. Rotate knob back until saw slides easily.
4. Hold the rail adjuster in position and lock the
screw again.
NOTE: ALWAYS readjust the system for use with
other rails.
SPLINTERGUARD
The guide rail is equipped with a splinterguard,
which has to be cut to size before the first use:
IMPORTANT: ALWAYS read and follow the guide
system instructions before cutting the splinterguard.
1. Set the speed of the plunge saw to level 5.
2. Place the guide rail on a scrap piece of wood.
3. Set the plunge saw on 5 mm cut depth
4. Place the saw on the rear end of the guide rail.
5. Turn the saw on, press it down to the set
cutting depth and cut the splinterguard along
the full length in one contiuous operation. The
edge of the splinterguard now corresponds
exactly to the cutting edge of the blade.
WARNING: To reduce the risk of injury,
ALWAYS secure the guide rail (z) with
a clamp (aa).
Door cutting (fi g. 9)
1. Place the plunge saw with the outer guard (y)
on a clean, flat floor.
2. Press the shoe (d) with the front side on the
door against the adjusted depth stop.
Dust extraction (fi g. 1)
Your tool is fitted with a dust extraction outlet (i).
WARNING: ALWAYS connect the
plunge saw to a dust extractor.
WARNING: ALWAYS use a dust
extraction device designed in
accordance with the relevant regulations
regarding dust emission.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
WARNING: If the saw blade is worn
replace it with a new sharp blade.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the unit with dry air as often as dirt is
seen collecting in and around the air
vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
D WALT offers saw blades specially designed for
E
your plunge saw.
Consult your dealer for further information on the
appropriate accessories.
EN GL IS H
WALT, have
E
39