ECOLAB EcoPlus PDRX Kurz- Betriebsanleitung Seite 43

Assembly and installation
Set alarm volume
1
Fig. 6: Set alarm volume
1. Press both tabs (pos. 1) of the electronics housing (pos. 2).
ð The electronics housing is unlocked and can be removed completely.
2. Turn over the electronics housing. For acoustic alarm purposes, the unit has a
buzzer (pos. 3).
3. The volume can be manually adjusted by turning the inner disc.
Open (pos. 4) = max. volume, closed (pos. 5) = min. volume
Power supply
2
1
1. Press the catches (pos. 1) on one side and release the electronic module (pos. 2)
by pulling it out of the lock.
2. Then press the catch on the other side and disengage the electronic module on this
side as well.
ð The electronics housing is unlocked and can be removed completely.
ð The WWC board (pos. 3) with the power supply and electronic cables
is located in the cover.
3. Turn over the electronics housing (pos. 4).
ð The cable glands are now freely accessible.
6
4. Feed the transformer cable (pos. 6) through the cable gland (pos. 7).
5. Check the correct fit of the seal (pos. 8).
6. Connect the transformer cable.
7. Tighten the cable gland so it is hand-tight.
WARNING!
Leave enough clearance on the connecting lines to enable the electronics
module to hang free and with no tensile loading.
At the same time, always take care to ensure that no cable loops form.
417102610 Rev. 01-12.2020
8
7
2
3
3
20
4
5
3
5
4