Conrad Electronic WS888 Bedienungsanleitung Seite 82

• Touch "SENSOR" repeatedly to select the memory position where to save the desired sensor.

Please bear in mind that the combination sensor can only be saved to memory position 9.
Tips for taking sensors into operation:
To safely take sensors into service, you can activate them first near the weather station. But the distance
between sensor and weather station must not be less than 1 m to avoid interference.
• Select "ADD" and the display will read (example for sensor 9: combination sensor):
SENSOR NO 9 - - SYNC ADD DEL SENSOR NO 9 - - SYNC ADD DEL SENSOR NO 9 - - SYNC ADD DEL
SENSOR NO 9 - - SYNC ADD DEL SENSOR NO 9 - - SYNC ADD DEL
• Now you can synchronise the desired sensor. Enter the batteries into the corresponding sensor and press its
synchronisation button. Read also chapter 10 g) for information on how to start and register the combination
sensor.
The data of the combination sensor appear automatically (after 6 minutes at the most) in the corresponding display
fields. The data of the remaining sensors will be displayed after selecting the memory position ("Sensor" field) in
the "OUTDOOR" display segment.
Identification of occupied memory positions
Memory spaces which are already occupied are highlighted by "USED" after the memory space number.

This information does, however, not indicate whether the corresponding sensor is really active.
This can only be recognized by missing or not up-to-date data during sensor selection and by the active
radio tower signal in the "OUTDOOR" field.
Deleting a sensor assignment
The serial number of a sensor can also be deleted from the sensor memory if required.
• First proceed as described at "Registration", select the desired sensor and then apply "DEL" (=delete) instead of
"ADD".
• The "USED" supplement after the sensor number is deleted and the memory space becomes available for
registering a new sensor.
82