Conrad Electronic WS888 Bedienungsanleitung Seite 103

4. Now clean the components of the rain collector. Clean also the drain hole in the plastic lower part of the rain
collector that you slid down the metal tube.
5. To reassemble the rain collector, insert first the tipping
bucket into its holder.

The magnet of the tipping bucket must be on the
side that faces the cable.
The two lower trapezoid pins must be properly
inserted into the bottom section of the holder.
In that way the tipping bucket will move smoothly.
6. Insert the rain collector into its mount. It will automatically
hold the tipping bucket as well.

Only one orientation is correct.
The cable of the rain collector and the magnet of
the tipping bucket must be on the same side.
The plastic lug on the other side must be properly
inserted into the holder!
7. Place the collection funnel back on the sensor carrier and turn it counter
clockwise to lock it.
Close the bottom part of the rain collector.
2 1
4
3
103