Conrad Electronic WS888 Bedienungsanleitung Seite 75

6. Screw the pedestal to the display console using the supplied
wrench and two socket screws.
7. The following picture shows how the cables are connected
and laid inside the pedestal. Make sure that the cables run in
the middle as shown in the picture so that the cover can close
properly.
Caution! The cables for the lighting of the glass base and the
USB cable can be plugged in one direction only! Do not use
force when plugging-in!
Excess lighting cable can be stowed away in a chamber of the
pedestal.
8. Now attach the cover of the pedestal:
Insert flat into the bottom guides in the pedestal (see also step
1), swing up until it latches into place.
Caution!
It should be easy to swing the cover up. If not, the cover does
not sit correctly in the bottom guides or the cables are not laid
correctly!
The picture shows how the cables should come out correctly.
6
7
8
75