Panasonic EY7960 Bedienungsanleitung Seite 10

Caution: DO NOT STARE INTO BEAM.
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
(2) Overheat warning lamp
Off Illuminated:
(normal Overheat
operation) (motor)
Indicates operation has
been halted due to motor
or battery overheating.
To protect the motor or battery, be
sure to note the following when
carrying out this operation.
• If the motor or battery becomes hot,
the protection
activated and the motor or battery
will stop operating. The overheat
warning lamp on the control panel
illuminates or flashes when this
feature is active.
• If the overheating protection feature
activates, allow the tool to cool
thoroughly (at least 30 minutes). The
tool is ready for use when the
overheat warning lamp goes out.
• Avoid using the tool in a way that
causes the overheating protection
feature to activate repeatedly.
• If the tool is operated continuously
under high-load conditions or if it is
used in hot-temperature conditions
(such as
overheating protection feature may
activate frequently.
• If the tool is used in cold-temperature
conditions (such as during winter) or
if it is frequently stopped during use,
the overheating protection feature
may not activate.
Flashing:
Overheat
(battery)
function will
during summer),
(3) Battery low warning lamp
Off
(normal
operation)
Excessive (complete) discharging of
lithium ion batteries shortens their
service life dramatically. The driver
includes a battery protection feature
designed
discharging of the battery pack.
• The
activates immediately before the
battery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warning
lamp flashing, charge the battery
pack immediately.
[Battery Pack]
be
For Appropriate Use of
Battery pack
Li-ion Battery pack (EY9L60)
• For optimum battery life, store the
Li-ion battery pack following use
without charging it.
• When charging the battery pack,
confirm that the terminals on the
battery charger are free of foreign
substances such as dust and water
etc. Clean the terminals before
charging the battery pack if any
foreign substances are found on the
terminals.
The life of the battery pack terminals
the
may
substances such as dust and water
etc. during operation.
• When battery pack is not in use,
keep it away from other metal
objects like: paper clips, coins, keys,
nails, screws, or other small metal
objects that can make a connection
from one terminal to another.
- 10 -
Flashing
(No charge)
Battery protection
feature active
to prevent
battery protection
be affected by
excessive
feature
foreign