Remote Motor Installation - De Dietrich DHD9001X Betriebsanleitung

3 - Push the (simbolo) key, within two seconds, and then the key. The cooker hood carries
out the filtering unit calibration moving it downwards or upwards for some centimetres; during
this phase, the keys on the keypad will flash.
Once the self-calibration procedure has been completed, push the key so that the ex-
tractable unit moves downwards. Turn the cooker hood on afterwards. Then open the little door
(Fig. 1D/1E) and remove the PVC protection from the grease filter; then install the filters as
shown in fig. 1F. Attention: the cooker hood calibration should be carried out properly, so that
your safety can be assured during the usage of the appliance and, especially, in the adjustment
of anti-deflection safety.
UTILISATION
This product is intended to extract fumes, fats, and steam from cooking. It has been designed
and made for use either in the suction or filter versions.
VERSION EVACUATION exterieure
The hood is equipped with an air outlet (Fig. A FIGURE 5) to convey smoke outwards (the flue
pipe and fixing flange are not supplied).
Check valve blockage
Warning: Before connecting the air exhaust hose, make sure that the check valves are free to
turn over freely.
In filtering application that the stop valve doesn't permit the entrance of wind and exhau-
sted air.
Filtering version
In the case an exhausting hole is not possible, the hood can be used in filtering version. For this
mode charcol filters are to be fitted inside the hood. Filtered air will be evacuated in the kitchen
trough a duct that conveys the air on a side of the cabinet (picture 6 bis).

- REMOTE MOTOR INSTALLATION

It is possible to install the motor in a remote position from the cooker hood, but it is necessary
to order the DHK900 - 989580001 kit.
33