Falcon 211 GEO T DL Benutzerhandbuch Und Installations- Und Wartungsanleitung Seite 42

English
Place the cooker in its intended position taking
care not to twist it within the gap between the
kitchen units as damage may occur to the
cooker or the units.
The rollers can be adjusted to level the cooker.
To adjust the height of the rear of the cooker
use the levelling tool supplied to turn the
adjusting nuts at the front bottom corners of the
cooker.
Adjust the height of the front roller to level the
cooker. Turn clockwise to raise the cooker and
anticlockwise to lower.
When you are satisfied with the height and level
raise the front of the cooker by one turn of the
front roller adjuster. Screw down the front feet to
meet the floor. Screw the front roller adjuster
anticlockwise to raise the front roller so that the
front of the cooker is supported on the feet, not
the front roller, to prevent accidental movement
of the cooker.
Leave the levelling tool in the storage drawer, so
that the customer can use it if they wish to move
the cooker.
Replace the drawer by locating on side runners
and push in.
Gas Connection
Restraining device
A restraining device should be fitted when the
cooker is connected to a flexible gas supply.
Any restraining device should be secured to the
fabric of the building and should be able to be
released so that the cooker can be pulled out for
cleaning and maintenance.
Flexible Gas Hose
A gas shut off valve must be fitted between the
gas supply and the connection hose. The
flexible hose (not supplied with the cooker) must
be in accordance with the relevant standards. If
in doubt contact, your supplier.
The rear cover boxes limit the position of the
supply point. The house gas supply needs to
terminate with a down facing connection.
view from the rear
A position for gas supply connector
B appliance gas inlet
The appliance connection is located just below
hotplate level at the rear of the cooker. ('B' in
the figure)
The hose should be fitted so that both inlet and
outlet connections are vertical so that the hose
hangs downwards in a 'U' shape.
Because the height of the cooker can be
adjusted and each connection is different it is
difficult to give precise dimensions. Ideally the
house supply connection should be in the
shaded area shown in the figure showing the
back of the cooker. ('A' in the figure)
After completing the gas connection, check the
cooker is gas sound with a pressure test. When
checking for gas leaks do not use washing up
liquid - this can corrode. Use a product
specifically manufactured for leak detection.
Pressure testing
The gas pressure can be measured at the pressure
test point on the gas connection block. Turn and light
one of the hotplate burners.
For Natural Gas the pressure should be 20mbar.
Reassemble burner top, making sure it is
reassembled in the correct way on the burner body.
42