Initial Calibration - OHAUS Valor 1000 -Serie Bedienungsanleitung

TM
Valor 1000 Series
2.3 Power
Connect the AC Adaptor to the AC mains supply. Connect the plug to the DC jack
on the bottom of the scale. The scale may be operated on the AC Adapter
connected to mains supply or 4 alkaline batteries.
Note: The AC adapter maybe optional or included with the scale, depending on the
region.
2.4 Rechargeable Battery Power
Allow the battery to charge for 12 hours before using the scale on battery power.
The instrument can be operated during charging, and the battery is protected
against overcharging. For maximum operating time, the battery should be charged
at room temperature.
Note: Availability is depending on region as accessory.
WARNING: Only charge the battery when the ambient temperature is between 0
and 140 ° F / 0 and 40 ° C.

2.5 Initial Calibration

When the scale is operated for the first time, a Span Calibration is recommended to
ensure accurate weighing results. Before performing the calibration, be sure to have
the appropriate calibration weight. You can also contact an OHAUS servicing scale
dealer for more information.
When the weighing unit is set to g or kg, the scale is calibrated in kg. When the
weighing unit is set to lb, oz or lb:oz, the scale is calibrated in lb.
Refer to section 4.1 for Span calibration procedures and section 4.3 for unit setting.
Maximum
Capacity (kg)
2 kg
3 kg
5 kg
6 kg
10 kg
15 kg
20 kg
30 kg
Maximum
Capacity (lb)
5 lb
6 lb
10 lb
15 lb
20 lb
30 lb
50 lb
60 lb
Span Calibration
Mass (kg)
2 kg
3 kg
5 kg
6 kg
10 kg
15 kg
20 kg
30 kg
EN-7
Span Calibration
Mass (lb)
5 lb
6 lb
10 lb
15 lb
20 lb
30 lb
50 lb
60 lb