Legal For Trade (For Approvable T Models); Settings; Verification - OHAUS Valor 1000 -Serie Bedienungsanleitung

EN-12

5. LEGAL FOR TRADE (for approvable T models)

When the scale is used in trade or a legally controlled application, it must be set up,
verified and sealed in accordance with local weights and measures regulations. It is
the responsibility of the purchaser to ensure that all pertinent legal requirements are
met. As the requirements vary by jurisdiction, the purchaser is advised to contact
their local weights and measures office for instructions about putting the balance
into service.

5.1 Settings

Before verification and sealing, perform the following steps:
1. Confirm that the available units are permitted by the local weights and
measures regulations.
2. Perform a calibration as explained in Section 4.1.
3. Press the LFT switch under the LFT switch cover as shown below. This cover
is located at the bottom of the scale.
a) Remove the LFT switch cover
b) Turn on the scale
c) Press the LFT switch. After that you will see "
the screen.
LFT switch cover

5.2 Verification

A weights and measures official must perform the verification procedure. Contact
the local weights and measures office for more information.
TM
Valor 1000 Series
LFt.ON
" is displayed on
LFT switch