Care And Maintenance; Accessories - Rothenberger ROWELD P160-630B Plus Professional Bedienungsanleitung

pressure P [bar] = welding surface A [mm²] x welding factor SF [N/mm²]
Welding factors (SF): PE = 0,15 N/mm², PP = 0,10 N/mm², PVDF = 0,10 N/mm²
4

Care and maintenance

To ensure that the welding machine functions properly, observe the following maintenance rec-
ommendations:
•
The guide rods must be kept free of dirt and grime. Replace guide rods whenever surface
shows signs of erosion or damage, otherwise hydraulic system may loose pressure.
•
Trimmer unit, heating plate, hydraulic unit may only be supplied with the voltage specified on
the type plates.
•
To achieve perfect welding results, it is essential to keep the heating plate clean. If the sur-
face is damaged or shows signs of erosion, the surface must be recoated or replaced. Mate-
rial residues on the heating plate surface reduces the non-sticking properties of the coating.
Remove all residues with non-linting paper and alcohol (heating plate must be cool!).
•
Before every start-up, check the oil level of the hydraulic unit (oil level should lie between full
and empty marks). Replenish hydraulic oil whenever necessary (HLP – 46, no.: 53649).
•
Change hydraulic oil (HLP – 46, no.: 53649) every six months.
•
To avoid malfunctions, regularly check the hydraulic unit for leaks, proper fit of connections
as well as the power cable for signs of damage or wear.
•
Protect the fast-on couplings on both the hydraulic unit as well as the hydraulic hoses from
dirt and grime. Remove any dirt or foreign objects prior to connecting.
•
The trimmer unit is equipped with two bi-directional blades. Rotate or replace blades when-
ever trimming performance is no longer up to expectations.
•
Always ensure that the pipe and workpiece ends, in particular the butt surfaces are clean.
Dirt or other foreign substances will shorten the serviceable life of the blades considerably
Pursuant to welding guidelines the welding machine must be inspected annual-
ly by the manufacturer or an authorised service workshop. Machines subjected
to above average use or strain should be inspected at shorter intervals.
5

Accessories

Accessory Name
ROWELD Roller block, galvanized, Gr.1
ROWELD Roller block, galvanized, Gr.2
ROWELD Roller block, galvanized, Gr.3
ROWELD Roller block, galvanized, Gr.4
Lifting device for P500B
Lifting device for P630B
Ratchet wrench, 13x17, L=250mm
Ratchet wrench, 19x22, L=310mm
Ratchet wrench, 24x27, L=360mm
Adaptors clamping inserts
24
surface of cylinder Az [cm²] x 10
ENGLISH
ROTHENBERGER Part Number
53055
53056
53057
53058
53410
53323
70272
70274
70276
www.rothenberger.com