How To Fill / Empty The Tank - Skandika Nemo IV Bedienungsanleitung

1. Remove the Fill Plug (#50) from the Upper Tank (#24).
2. To fill tank with water, refer to Fig. A. Insert the Funnel (#52) into the tank, then use a
cup or the Pumping siphon (#53) and a bucket to fill the tank. Use the water level gauge
on the side of the tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the Pum-
ping siphon (#53) to pump out the water from the tank into the bucket.
4. Insert the Fill Plug (#50) into the Upper Tank. Wipe excess water off of the frame.
NOTES:
• Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is included.).
Never use pool chlorine or chlorine bleach. This will damage the tank and void the war-
ranty.
• Add a water purification tablet every 6 months or as needed. If water remains cloudy,
replace the water in the tank.
• Water from the tank is not suitable for consumption. Dispose of the water after pum-
ping it out from the tank.
The water level
• See Fig. A: The water level gauge is on the side of the tank. The maximum fill level is 6.
Never overfill the tank over this limit! Filling the tank over this limit will void the war-
ranty.
• The resistance depends on the water level in the tank. Water level 1 is the lowest resis-
tance. Level 6 is the highest resistance.
31
Water level label

HOW TO FILL / EMPTY THE TANK