Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HOW TO FILL / EMPTY THE TANK
1.
Remove the plug (M) from upper tank.
2. Fig. A shows how to fill the tank with water. Use the supplied siphon pump (I) and a bucket of water to fill the
tank. The pump is placed in the bucket of water and the flexible hose must go into the water tank. Ideally, the
bucket of water should be higher than the water tank of the appliance. Pay attention to the filling quantity,
which is indicated on the side wall of the tank by the level indicator.
3. Illustration B shows how to empty the tank. Place a bucket next to the device. Use the syphon pump (I) to
pump out the water from the tank into the bucket.
4. Once completed, re-insert plug (M) into the upper tank. Wipe away excess water from the frame.
NOTES:
•
The tank may be filled with tap water or distilled water. Add a waterpurification tablet if necessary. Never use
chlorine or chlorine bleach - this could damage the tank and lead to cancellation of the warranty.
•
Depending on the environment of the installation site and the frequency of use, the water should be changed
regularly, but at the latest every 6 months or if there are signs of discolouration, bacteria or algae, etc. Use
distilled water if possible!
•
Never expose the tank to direct sunlight and empty it if it is not going to be used for a long time.
•
Water purification tablets (enclosed) are suitable for keeping the water clean. One tablet is sufficient for the
maximum filled water tank. Stir the water well after adding one tablet. Add one tablet to the tank about every
2-3 months.
•
The water from the tank is not suitable for consumption. After emptying, pour the water away.
Make sure that all parts are properly tightened before using the rower:
STEP 5:
The water level
1.Remove the tank plug (M) from the top of the tank.
•
Fig. A shows the fill level indicator. You may fill the tank to a maximum of filling level 6 (approx. 14 litres).
2.To add water to the tank (figure 1) insert the straight rube from water pump (I) into a container of
Never overfill the tank beyond this! This will invalidate the warranty.
water and the flexible tube from the water pump into the rower tank. Make sure the container of water is
higher than the rower water tank. Squeeze the pump several times to add water to the rower tank until
•
The resistance when rowing depends on the level of the tank. Level 1 means the lowest resistance when ro-
desired resistance level is achieved as per markings on the side of the tank. The more water in the
wing, level 6 is the highest resistance.
tank, the higher the resistance. Replace tank plug (M) once designed level is reached.
3.To empty the rower water tank, you need to reverse the filling procedure (figure 2)
A
Fig 1
M
I
Moving the Rower:
1) Move the seat to the front of the seat rail. moving the rower. Lift the rower from the rear feet tube
until the wheels in the front feet tube make contact with the floor and allow for movement.
25
14.0L
MAX FILL
6
13.0L
5
WATER LEVEL
12.0L
4
R E S I S T A N C E
10.0L
3
9.0L
2
RESIS.
8.0L
MIN. FILL
1
HOW TO FILL / EMPTY THE TANK
B
Fig 2
I
M
Werbung
Inhaltsverzeichnis
