Performing A Functional Test; Using The Parking Aid - Dometic MagicWatch MWE890K Bedienungsanleitung

Performing a functional test

Restoring the factory settings
➤ Press the
key for approx. 6 s.
SENS
✓ The control electronics acknowledge the selected setting by a series of acoustic
signals.
✓ The system restarts when you release the button.
10 Performing a functional test
To test the parking aid, drive towards something slowly such as a wall.
A
NOTICE!
Be very careful when you operate the device for the first time, and make
sure that you familiarize yourself with the various sequences of beeps
(fig. 0).
11

Using the parking aid

The front sensors are activated automatically once the speed of the vehicle is
between 0 and 15 km/h and the ignition is switched on.
If the speedometer signal cannot be detected, the front sensors are activated when
the ignition is switched on or when you engage the reverse gear. After 20 s, they are
automatically deactivated if there is no obstacle in the detection area. If there is an
obstacle in the detection area, they are then switched off when there is no longer an
obstacle in the detection area.
As soon as there is an obstacle within the detection range, a repeated signal tone is
emitted.
As you approach, the tone sequence changes, depending on the zone in which the
obstacle is, thus indicating the distance (fig. 0).
A
NOTICE!
Stop the vehicle immediately and investigate the situation (getting out if
necessary), if the following happens while you are manoeuvring:
when manoeuvring, the device first indicates an obstacle and the tone
sequence speeds up normally (e.g. from slow to medium). Suddenly the
signal tone slows down, or no obstacle is indicated at all.
This means that the original obstacle is in the blind spot of the sensors
(construction-related characteristic), and it is possible to hit it.
10
MWE890K
EN