Dometic MagicWatch MWE890K Bedienungsanleitung Seite 11

MWE890K
✓ The control electronics acknowledge the selected setting with an acoustic
signal:
– a short beep: loudspeaker off
– two short beeps: low volume (factory setting)
– three short beeps: high volume
– four short beeps: no function
– five short beeps: no function
Setting the detection range of the sensors
➤ Press the
button for approx. 3 s.
VOL
The detection range switches in the order of "60 cm – 85 cm – 110 cm –
60 cm ...".
✓ The control electronics acknowledge the selected setting with an acoustic
signal:
– a short beep: 60 cm
– two short beeps: 85 cm (default setting)
– three short beeps: 110 cm
Setting the sensitivity of the sensors
➤ Press the
button briefly.
SENS
The sensitivity switches in the order "Low – Medium – High – Low ...".
✓ The control electronics acknowledge the selected setting with an acoustic
signal:
– a short beep: very low
– two short beeps: low
– three short beeps: medium (default setting)
– four short beeps: high
Adjusting the filter
If the control electronics must be installed near electrical cables, transmission errors
may occur.
➤ Press the
key for approx. 3 s.
SENS
The noise filter is switched in the order "Standard – High – Standard".
✓ The control electronics acknowledge the selected setting with an acoustic
signal:
– four short beeps: standard noise filter
– two short beeps: maximum noise filter (factory setting)
EN
Setting the system
9