Hob Functions - IKEA FÖRDELAKTIG AA-2296800-1 Bedienungsanleitung

ENGLISH 19

Hob functions

This function prevents accidental use of the appliance. This cannot be used during a cooking operation.
To enable: remove all cookware from the appliance, turn the appliance off. Turn the appliance on and
within 3 seconds press and hold any of the 5 digits for 3 seconds. Release and slowly swipe along the
Child lock
power bar from 0 to BOOST. An "L" will appear on all 5 digit displays.
To disable: turn the appliance on and then press and hold any of the the 5 digits for 3 seconds. Release
and slowly swipe along the power bar from BOOST to 0. The 5 digit displays will light up indicating a 0
power level.
It is possible to lock the hob functions during use, e.g. to clean the hob. The function is enabled even if
the hob is switched off and on again.
If the electricity supply is cut, the function is disabled.
Lock
To enable: press and hold for 1 second.
To disable: press .
Every cooking area can be set to an additional power level for a maximum of 5 minutes.
To enable: select one of the 4 cooking areas and select "P" on the power bar. The corresponding digit
Boost function
indicates .
To disable: select one of the other possible values on the power bar.
The timer allows a specific cooking area to be switched off when the set time expires.
The cooking areas can be programmed individually because each one has its own timer.
To enable: With the cooking area in operation, press to access the timer management controls for that
zone.
The 3 digits indicate "0 0 0". Press "+" or "-" to set the timer countdown.
Cooking zone
Hours - Tenths - Minutes
timer
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The function can
be interrupted by pressing any key.
If the timer is enabled for more than one cooking area, the 3 digits will always show whichever timer is
about to finish first.
To deactivate: with the cooking area in operation, press to access the timer management controls for
that zone.
Set the three digits to "0 0 0" using "+" or "-" or press the On/Off key.