IKEA FÖRDELAKTIG AA-2296800-1 Bedienungsanleitung Seite 5

ENGLISH
• The manufacturer cannot be held responsible for any damage
resulting from incorrect or inadequate installation.
• Check that the mains power supply corresponds to the one in-
dicated on the rating plate affixed to the inside of the product.
• The cut-out devices must be installed in the fixed system ac-
cording to wiring system regulations.
• For Class I appliances, check that the domestic power supply
has a suitable earthing connection.
• Connect the suction hood to the flue using a suitable pipe.
Refer to the purchasable accessories indicated in the installa-
tion manual (for circular pipes: minimum diameter 120 mm).
The length of the discharge piping must be as short as pos-
sible.
• Connect the product to the mains using an omnipolar switch.
• The air venting regulations must be complied with.
• Never connect the suction appliance to ducts carrying com-
bustion fumes (heaters, fireplaces, etc.).
• If the suction hood is used alongside non-electrical appliances
(e.g. appliances with gas burners), it is necessary to guarantee
a sufficient level of ventilation in the room, to prevent any ex-
haust backflow. When the cooking appliance is used together
with other appliances using non-electrical power sources, the
negative pressure in the room must not exceed 4 Pa, to pre-
vent the fumes being sucked back into the room by the cook-
ing appliance.
• The air must not be discharged into a pipe that is also used as a
flue for appliances powered by gas or other fuels.
• If the power cable is damaged, it must be replaced by the man-
ufacturer, an authorised service centre or a qualified techni-
cian, to avoid any risk of danger.
• Connect the appliance plug to a socket that complies with cur-
rent regulations and is in an accessible area.
5