Philips AVENT SCD535 Benutzerhandbuch Seite 19

Why is the connection lost every now and then?
Why are there sound interruptions?
• The baby unit and the parent unit are probably
close to the outer limits of the operating
range. Try a different location or decrease the
distance between the units. Please note that
it takes about 30 seconds each time before a
connection between the units is established.
• You may have placed the parent unit next to a
transmitter or other DECT appliance, such as
a DECT telephone or other 1.8GHz/1.9GHz
baby monitor. Move the parent unit away from
the other appliances until the connection is
re-established.
What happens during a power failure?
• If the parent unit is sufficiently charged,
it continues to operate during a power failure,
both inside and outside the charger. If there are
batteries in the baby unit, it also continues to
operate during a power failure.
Is my baby monitor secure from eavesdropping
and interference?
• The DECT technology of this baby monitor
guarantees no interference from other
equipment and no eavesdropping.
The operating time of the parent unit is The operating time of the parent unit The operating time of the parent unit
supposed to be up to 24 hours. Why is 24 hours. Why is 24 hours. Why is
the operating time of my parent unit shorter? operating time of my parent unit shorter? operating time of my parent unit shorter?
• When the rechargeable battery pack of the
geable battery pack of the geable battery pack of the
parent unit has been charged for the first time, has been charged for the first time, has been charged for the first time,
the operating time is less than 24 hours. The
rechargeable battery pack only reaches its full
capacity after you have charged and discharged
it at least four times.
• The volume of the parent unit may be set too
high, which causes the parent unit to consume
a lot of energy. Decrease the volume of the
parent unit
• The microphone sensitivity level of the baby
unit may be set too high, which causes the
parent unit to consume a lot of energy.
Decrease the microphone sensitivity level in the
menu of the parent unit.
All manuals and user guides at all-guides.com
Why doesn't the battery symbol appear on
the display of the parent unit when I start to
recharge the parent unit?
• It may take a few minutes before the battery
y monitor y monitor
is is
symbol appears on the display of the parent
unit when you charge the parent for the first
time or after a long period of disuse.
19