Warnings And Cautions - Omron HBP-1320 Gebrauchsanweisung

HBP-1320-E main.book Page 3 Tuesday, May 8, 2018 5:16 PM

Warnings and Cautions

Usage warnings and cautions
Storage/Setup
Warning
Install the unit in a location close to a power outlet where the AC adapter can be easily disconnected. If the
power cannot be quickly disconnected when an abnormal condition occurs, an accident or fire may result.
Do not use the cuff or AC adapter to lift the unit, it can also cause the unit to malfunction.
If the unit has broken down, contact your OMRON retail dealer or distributor.
Do not use in combination with a hyperbaric oxygen therapy device, or in an environment where
combustible gas may be generated.
Do not use in combination with magnetic resonance imaging (MRI) equipment. If MRI is to be
performed, remove cuff connected to the unit from the patient.
Do not use with a defibrillator.
Do not install the unit in the following locations:
- Locations subject to vibration such as ambulances and emergency helicopters.
- A location where there is gas or flame.
- A location where there is water or steam.
- A location where chemicals are stored.
Do not use at extremely high temperature, high humidity, or high altitude. Use only within the required
ambient conditions.
Do not subject the unit to intense shock.
Do not place heavy objects on the AC adapter cable, or allow the unit to sit on the cord.
Clinical testing has not been conducted on newborn infants and pregnant women. Do not use on
newborn infants and pregnant women.
Do not plug in or unplug the AC adapter with wet hands.
During measurement, make sure that no mobile phone or any other electrical devices that emit
electromagnetic fields is within 30 cm of this monitor. This may result in incorrect operation of the
monitor and/or cause an inaccurate reading.
Caution
Do not install the unit in the following locations:
- Locations with dust, salt, or sulfur.
- Locations directly exposed to sunlight for extended periods of time (in particular, do not leave in
direct sunlight or near a source of ultraviolet light for extended periods, as ultraviolet light will cause
deterioration of the LCD).
- Locations subject to vibration or shock.
- Near heaters.
Do not use in a location with noise-emitting equipment such as a room with MRI, CT, X-ray, or HF
surgical equipment or an operating room. Noise from the equipment may interfere with the operation
of the unit.
EN
3