Fancom AT Anleitung Seite 12

3.2 Maintenance
The AT(M) requires no specific maintenance. Fancom recommends that your installation technician inspects the
complete climate installation, of which the AT(M) is a component, every half-year.
Disconnect electrical power before inspecting or servicing equipment.
Inspect the AT(M) periodically for any damages.
Check the AT(M) for proper functioning regularly.
Fancom recommends that your installation technician inspects the complete climate installation, of
which the AT(M) is a component, every half-year.
3.2.1 Cleaning
The AT(M) may be cleaned wet, but consider the following:
Do not use a high pressure hose or aim at motor seals or openings at close range.
Do not use water or high pressure cleaners for lengthy periods. The AT(M) contains rotating parts,
the throttle vanes. This means the construction is not completely waterproof. Water in the AT(M) can
cause mall funtions.
Do not turn the AT(M) during or after the cleaning process. Note that the air inlet side is always on
the bottom side.
After installation, there must always be power to the AT(M). This prevents the formation of
condensation in the AT(M).
3.3 Disposal / recycling
When disposing the AT(M) please comply with all relevant requirements and regulations applicable in your
country.
9