Lubrication; Cleaning; Troubleshooting; Safety Instructions - Heiniger Xplorer/E Originalbetriebsanleitung

NOTE!
The provided oil is non-toxic and produces no irritation on contact with the skin or
X
the mucous membranes. This paraffin oil degrades to some 20 % after 21 days
(CEL-L-33-T-82).
Oil the blades prior to, during and after every use.
X
Oil the blades no later than when the blades leave streaks or slow down.
X
Apply several drops of oil on the front and on the sides of the clipping blades (see
X
Fig. 15)
Immediately replace damaged or notched blades in order to avoid injuries.
X
6.10

Cleaning

CAUTION!
IMPROPER CLEANING.
RISK OF DAMAGING THE CLIPPER!
Use only a dry cloth and the brush provided to clean the clipper.
X
Never use compressed air for cleaning the clipper.
X
Housing of the clipper
Clean the housing of the clipper with a dry cloth.
X
Clipping blades, clipping head and charger
Disconnect the charger from the power supply.
X
Use the brush supplied to clean the clipping blades, clipping head and charger.
X
Lubricate the clipping blades as described in chapter 6.9.
X
Remove any hair from the charging bay.
X
Clean the terminals with a dry cloth if necessary.
X
7

Troubleshooting

7.1

Safety instructions

DANGER!
DANGER OF FATAL ELECTRIC SHOCK!
Fatal electric shocks can result from contact with electrically live conductors or com-
ponents!
Switch the equipment off before troubleshooting the problem.
X
Repairs to electrical devices must only be carried out by the factory service de-
X
partment or specialists who have been trained by the manufacturer.
During the warranty period the device must be opened only by personnel authorised by the
manufacturer, otherwise the warranty will be void.
7.2

Causes of malfunctions and their rectification

Malfunction
Upper blades moving
too little.
Top blade does
not move
Adjusting knob jam-
med.
Leaf springs in the
head mount are
too loose.
16
Cause
Leaf springs broken.
Eccentric square or eccentric
shaft worn (insufficient

lubrication).

Defective gear wheel.
Thread dirty or rusty.
Pressure spring jammed.
Comb plate screws loose.
Translation of the original instructions / Cattle and Horse Clipper
Rectification
Notify customer service.
Notify customer service.
Notify customer service.
Tighten the comb plate screws.