Analog Equipment: Speedometer; Warning Led Function - Malaguti SPIDER MAX GT 500 Diagnose-Handbuch

SPIDER MAX 500
Note 1: While the confirmation message is on, the button function is disabled.
Note 2: The V.BELT ALARM can be de-activated at any time without waiting for the decreasing counter, associated
with this function, to get to the zero.
Note 3: After de-activating the alarm, the system automatically sets the equipment to the standard operation
mode. To access the de-activation configuration again, repeat all the operations above described.
5. UNIT OF MEASUREMENT AND SOFTWARE
REVISION SELECTION
Every time that the battery or the battery fuse are disconnected, the
equipment prompts the user to select the unit of measurement (Km/h or
Mph) by pressing the button while the main menu is displayed. The (one-
letter coded) software revision, release week and year (F. 15) are shown in
the same window.
6.

ANALOG EQUIPMENT: SPEEDOMETER

The equipment displays the value of the current speed in analog mode, through the stepper motor, according to the
same principles described in paragraph 1.1.
7.

WARNING LED FUNCTION

7.1 Fuel level indicator function
The system receives the information prompting to switch on the micro control device, as described in paragraph 1.6. If
the resistive sensor is disconnected, the led starts blinking (f=1 Hz, duty=50%).
7.2 Radiator coolant temperature led function
The system receives the information prompting to switch on the micro control device, as described in paragraph 1.5. If
the resistive sensor is disconnected, the led starts blinking (f=1 Hz, duty=50%).
7.3 Direction indicator led function
The system must activate the led when the connector inputs no. 2 and no. 16 are in a high state, when the direction
indicators are switched on (see page 20).
The signal reaching the equipment must be already alternate.
7.4 High beam led function
The system must activate the led when the connector input no.15 is in a high state, when the high beams are switched
on (see page 20).
7.5 Beam function led
The system must activate the led when the connector input no. 3 is in a high state, when the switching beams are
switched on.
7.6 Injection function led
The system receives the information prompting to switch the micro control device on, according to the state of the input
no. 20; a low logic state determines the led to switch on (see page 20).
7.7 Oil function led
The system receives the information prompting to switch the micro control device on, as described in paragraph 5.6.
7.8 Immobilizer function led
The system receives the information prompting to switch the connector input no. 22 on; a low logic state determines the
led to switch on. The led can be turned on even when the key switch is moved to the "OFF" position (see page 20).
7.9 Side stand/engine stop function led
The system receives the information prompting to switch the micro control device on according to the state of input no.
12; a low logic state determines the led to switch on.
All manuals and user guides at all-guides.com
17
F. 15 Unit of measurement and Software
Revision selection
12/04
A