Athena GET RX1 PRO Installationsanleitung Seite 4

5.
Insert the GET RX1 Pro ECU
into the rubber support and
connect it to the OEM connector.
Make sure the connectors are
properly plugged in, and the
retainer clip is fully engaged.
6.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
ATTENTION:
For Honda CRF 250 R 2018-2021 and for Honda CRF
450 R 2018-2020, the OEM traction control and the
OEM map switch push button will not work when
GET RX1 Pro ECU is installed. Please only use GET
Map Switch (included in the kit) and GET LC-GPA
module (sold separately). For Honda CRF 450 R
2019-2020 the OEM mode button (blue one) can be
used to manage GET LC-GPA when installed.
7.
If included in the kit, install
GET WiFi-COM by following the
procedures in the dedicated manual.
8.
Re-install the seat and the
front side panels.
EN 6
F. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative on the Restriction of
the Use of Certain Hazardous Substances.
G. DISPOSAL
Pursuant to art. 26 of Legislative Decree no. 49 of 14
March 2014, "Implementation of Directive 2012/19/EU
on waste electrical and electronic equipment (WEEE)".
The crossed-out wheelie bin symbol displayed on a product or its
packaging indicates that when the equipment reaches the end of its life
cycle it must be disposed of separately from other waste for purposes
of treatment and recycling. Once such products reach the end of their
life cycle, users may dispose of them free of charge at special municipal
centres for the collection of waste electrical and electronic equipment, or
return them to the distributor under one of the following arrangements:
- very small products, i.e. equipment with no external dimension
exceeding 25 cm, may be returned with no obligation to buy
to distributors whose sales areas dedicated to electrical and
electronic equipment exceed 400 m2. Distributors with smaller
sales areas are not obliged to participate in this scheme.
- products of dimensions greater than 25 cm may be returned to
distributors under a "one for one" arrangement, i.e. the distributor
is only obliged to receive the product in return for the purchase of
a new, equivalent product, with one new product being purchased
for every waste product returned.
The separate collection and subsequent processing of products for
purposes of recycling, treatment and environmentally sound disposal
helps avoid potentially harmful effects on the environment and
human health, and facilitates the reuse/recycling of the materials
contained in the products. Users abusively disposing of products are
subject to the penalties applicable under the respective legislation.
7 EN