Storage; Electrical Connection - Scheppach PL55 Original Bedienungsanleitung

Notice!
Water that has penetrated the housing may cause a
short circuit, improper cleaning could damage the
plunge saw.
• Do not wash the plunge saw and also do not spray it
off with a water jet.
• Never immerse the plunge saw in water.
• Make sure that no water penetrates the housing.
• Do not use any aggressive cleaners, or sharp or me-
tallic cleaning utensils such as knives, hard scrapers
or similar. They could damage the surfaces.
1. Clean the plunge saw directly after each use.
2. Keep the protective devices as free of dust and dirt
as possible.
3. Rub the plunge saw off with a clean cloth or blow
it off with low-pressure compressed air. Wear pro-
tective goggles when using compressed air.
4. Use a damp cloth and a small amount of soft soap
if it is heavily soiled.
Note: Proper, regular care is not only important for
safe use, but also helps to extend the service life of
the plunge saw.
Replacing the connector cord
If the mains connection line of the plunge saw is dam-
aged, it must be replaced by the manufacturer, its after
sales support or a similarly qualified person in order to
prevent risks.
Checking the plunge saw
Regularly check the condition of the plunge saw.
Among other things, check to make sure:
• that the switches are not damaged,
• that the accessories are in proper condition,
• that the mains connection line and the mains plug
are not damaged,
• that the vents are unobstructed and clean. If applica-
ble, use a soft brush to clean them.
If you identify any damage, you must have the
plunge saw repaired by a specialist workshop to
prevent risks.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Carbon brush, saw blade
* Not necessarily included in the scope of delivery!
36 | GB
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

12. Storage

Store the device and its accessories in a dark, dry and
frostproof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.

13. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Important information
In the event of an overloading the motor will switch it-
self off. After a cool-down period (time varies) the mo-
tor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
www.scheppach.com