MARIMEX Comfort Spring Aufbauanleitung Seite 47

EN
Step 3
Lift up the frame on one side and connect
the leg tubes to the frame. Repeat the
procedure on the other side so that the
same types of legs are placed diagonally.
Note: Two or more persons are required to
lift the frame on the opposite side.
Step 4
To prepare the jumping mat to be attached
to the trampoline you must first attach the
protective net.
Lay out the net so that the net opening
(zipper) is located in the middle of the
longer side of the jumping mat. There is a
hem with holes at its lower edge. Thread
the metal triangle of the jumping mat
through the mesh hole as shown and proceed around the entire circumference until
you have threaded all the triangles.
Step 5
Now you need to attach the jumping mat to
the trampoline frame.
Connect one corner triangle to the corner
of the trampoline: attach the more curved
end of the spring to the metal triangle,
then the other end of the spring to the
hole of the corner frame tube. Use the
second spring to attach the same triangle
to the same corner. Next, connect the diagonal corner of the jumping mat to the
diagonal trampoline corner by using a tensioning tool. Do the same and connect
the remaining corners of the jumping mat.
Step 6
Repeat to attach the springs to the
corresponding holes on frame tube
alternately.
47