Werbung
E E l l e e k k t t r r i i s s c c h h e e r r A A n n s s c c h h l l u u s s s s I I I I I I
E E l l e e c c t t r r i i c c a a l l C C o o n n n n e e c c t t i i o o n n I I I I I I
Indicator Lights and Switches
Main switch: switches the device ON and OFF.
§
The required high voltage has been preset and measured at the factory.
Any modification of the high-voltage settings is
result in the partial or total failure of the device.
§
The
green
It goes out when the device is switched off
§
The
yellow
not interrupt the operation of the device. You should, however, pay attention to these
signals as the electrostatic filters become increasingly less efficient if cleaning is not
performed. The light goes out after the cleaning of the filters.
Alternatively, a maintenance interval can be set.
It is preset to 200 operating hours at the factory.
When the collector maintenance is indicated by the
yellow light after expiry of this time and the collectors
are cleaned, the preset counter must be reset with
the appropriate key. The expired time is set to zero
and the yellow light goes out. The maintenance interval
can be set as desired to specific operating conditions.
§
Please observe the cleaning
instructions on page 24!
§
The
red
fault signal light indicates the following faults: see page 21/ 22.
All manuals and user guides at all-guides.com
operational status light indicates the trouble-free operation of the UCE device.
filter cleaning light indicates when the filters should be cleaned but does
§ i i n n a a d d m m i i s s s s i i b b l l e e
and will
§ o o r r i i n n t t h h e e e e v v e e n n t t o o f f a a f f a a i i l l u u r r e e . .
Adjustment keys
Reset-
key
2 2 0 0
Werbung
