How To Use The Accessories; Transportation; Storage; Care And Service - Kärcher VC 4 Cordless myHome Originalbetriebsanleitung

How to use the Accessories

General instructions for use
 Which accessories are included in the scope of de-
livery is shown on the device packaging.
 Accessories not included in the packaging can be
purchased in a KÄRCHER specialist shop or from
www.kaercher.com.
 Test the accessory at an inconspicuous point before
using it in a sensitive area.
 Follow the manufacturer's cleaning instructions.
 Connect the motor-driven electric nozzle to the suc-
tion pipe or the hand-held device.
 Also connect the other accessory parts, such as
crevice nozzle, to the hand-held device or push it di-
rectly onto the suction pipe to increase the reach.
Motor-driven multi-function brush
Ideal for hard floors and carpets.
The motor-driven multi-function brush removes dirt
stuck between the carpet fibres particularly effectively.
2-in-1 dust brush
The frame with the surrounding bristles can be taken off
pressing the unlocking button.
● The soft brush is suitable for furniture with hard sur-
faces
● The wide brush is used to clean upholstered furni-
ture, curtains, etc.
Crevice nozzle
For edges, joints, heaters and areas that are difficult to
reach.
Soft brush
The soft brush has particularly soft bristles for cleaning
sensitive surfaces such as keyboards, lamps, etc.
Flexible crevice nozzle
The flexible crevice nozzle increases the reach. For
cleaning hard-to-reach places, such as between the car
seats.
Flexible extension hose
Due to the extension and flexibility, hard-to-reach areas
such as in the car can be reached and cleaned.
Large upholstery nozzle
For cleaning textile surfaces such as sofas, armchairs,
mattresses, car seats, etc.
Soft motor-driven brush (Hardfloor nozzle)
For hard floors and sensitive wooden floors. Extracts
coarse and fine dirt simultaneously.

Transportation

The battery has been tested in accordance with the rel-
evant rules for international transport, and can be
transported / shipped.

Storage

ATTENTION
Moisture and heat
Risk of damage
Store batteries only indoors in a dry place with low hu-
midity and temperatures below 20°C.

Care and service

General care instructions
 Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
Cleaning the air inlet filter
Note
The device can be cleaned manually or using a filter
cleaning device.
1. Switch off the device.
2. Manually cleaning the air inlet filter.
a Pull the soiled air inlet filter down at the filter stick,
carefully beat it and clean it with a damp cloth or
running water.
Illustration K
b Reinsert the fully dried air inlet filter.
c Check for correct seating.
3. Cleaning the air inlet filter with a filter cleaning
device.
Note
A new air inlet filter must be installed in the dust contain-
er during filter cleaning.
a Push the filter cleaning device on to the suction
pipe branch and pull the air inlet filter out of the
device using the filter stick.
b Push the soiled air inlet filter into the filter clean-
ing device.
c Insert a new air inlet filter into the dust container.
Illustration L
d Switch on the device and let it run in boost mode
while turning the side cover.
Illustration M
e Remove the cleaned air inlet filter from the filter
cleaning tool and reinsert it in the dust container
after removing the new air inlet filter.
f Check that the air inlet filter is correctly seated.
Cleaning the dust container and cyclone filter
Note
The dust container and cyclone filter can be cleaned
with or without removing the dust container.
We recommend removing the dust container from the
device for easy cleaning.
Note
Before cleaning the dust container and cyclone filter,
empty the dust container, see chapter Ending operation
1. Switch off the device.
2. Press the unlocking button for the dust container
and remove the dust container from the hand-held
device.
Illustration N
a Remove the cyclone filter from the dust container
by turning it anticlockwise.
b Remove the cyclone filter from the dust container
and take the air inlet filter out of the cyclone filter.
Illustration O
ATTENTION
Short circuit hazard
There are cables or contacts in the dust container and
cyclone filter for the power supply.
Make sure that the cables or contacts do not get wet
when cleaning.
3. Clean the dust container and cyclone filter with a
soft brush or a slightly damp cloth.
Illustration P
4. Clean the air inlet filter, see chapter Cleaning the air
inlet filter
English 13