How To Use The Accessories; Important Application Instructions - Kärcher SC 2.600 C Bedienungsanleitung

Refilling Water
In case of water shortage, the indicator
lamp "water shortage" glows red in the wa-
ter reservoir and a signal canb e heard.
Note:Every time there is not enough water
in the steam boiler, the pump automatically
supplies water from the water reservoir into
the steam boiler. If the water reservoir is
empty, the water pump is not able to fill the
steam boiler and the steam tapping is
blocked.
Fill the water reservoir up to the "MAX"
marking.
Note: The water pump tries to fill the steam
boiler in short intervals. If the filling is suc-
cessful, the steam tapping is release imme-
diately, and the red indicator lamp goes out.
Adjusting the Steam Quantity
Use the selector switch for the steam vol-
ume to regulate the discharged steam. The
selector switch has three positions:
Maximum steam volume
Reduced steam volume
No steam - child protection
Note: In this lever position, the steam
lever cannot be used.
Set selector switch to the required
steam volume.
While operating the steam switch, always
direct the steam gun at a separate piece of
cloth until the steam is emitted evenly.
Note: The heating of the steam cleaner
is turned on in regular intervals during
the operation of the appliance in order
to maintain the pressure in the boiler at
a constant level. Then the indicator
lamp (heater) blinks green.
Turning Off the Appliance
Press the OFF switch to turn off the ap-
pliance.
Disconnect the mains plug from the
socket.
Press the cover of the appliance connector
to the bottom and disconnect the steam
plug from the appliance connector.
Empty the residual water from the water
reservoir.
Storing the Appliance
Illustration
Insert the round brush into a small hold-
er for accessories.
Insert the manual nozzle and detail noz-
zle onto each extension pipe.
Put the extension pipes into the large
acessory compartments.
Hook the floor nozzle into the parking
position.
Wrap the steam hose around the exten-
sion pipes and insert the steam pistol
into the floor nozzle.
Stow away the mains cable in the ac-
cessory holder for the mains cable.

How to Use the Accessories

Important application instructions

Cleaning of Textiles
Prior to treatment with the steam cleaner,
always check the reaction of the textiles in
an inconspicuous location: Steam heavily
at first, then let dry and then check for col-
our or shape changes.
Cleaning of Coated or Lacquered
Surfaces
Be careful when you clean kitchen and liv-
ing room furniture, doors, parquet, lac-
quered or plastic-coated surfaces. The
wax, furniture polish, plastic surfaces or
paint can come loose or stains can be cre-
ated. Therefore, always clean these surfac-
es with a steamed cloth only.
Caution
Never direct the steam jet at glued edges
as the edge band may loosen. Do not use
the steam cleaner on unsealed wooden or
parquet floors.
Cleaning of Glass
In case of low outside temperatures, especially
in the winter, warm up the window pane by
slightly steaming the entire glass surface. This
will prevent tensions on the surface which might
lead to glass breakage.
– 9
EN
-
19