Kärcher sc 1402 Kurzanleitung Seite 24

Power nozzle (D4)
The power nozzle is attached directly or
using the extension piece (D2) on the detail
nozzle. The power nozzle increases the
emission speed of the steam.
Application:
– removal of especially stubborn dirt
– cleaning out corners, joints, etc.
Manual nozzle (E1)
Pull the terry cloth cover (E2) over the ma-
nual nozzle.
Application:
– small, washable surfaces, such as kit-
chen surfaces made of plastic, tiled
walls
– windows, mirrors
– furniture fabrics
– vehicle interior, windscreens
– bath-tubs
Window nozzle (F1)
Application:
– windows
– mirrors
– glass surfaces on shower cubicles
– other glass surfaces
Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly. Then
push the lock (C3) to the rear to prevent
an undesired actuation of the steam
switch (C4). Wipe the glass surface in
straight lines from the top to the bottom
using the rubber lip of the window
nozzle. Wipe the rubber lip and the bot-
tom edge of the window dry after each
strip.
Before cleaning with the window
nozzle, disolve fat residue using the
manual nozzle (E1) and a terry cloth co-
ver (E2) .
24 English
Floor nozzle (H1)
Application:
– all washable wall and floor coverings,
e.g.: stone floors, tiles, and PVC floors.
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Turn and exchange the floorcloth in re-
gular intervals. Thus, you improve the
ability to pick up dirt.
Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a lon-
ger period of time.
If there are residues of detergents or
floor cleaning products (e.g. wax, liquid
polish) on the surface to be cleaned, st-
reaks may form during the cleaning.
These streaks normally disappear after
a repeated use of the steam cleaner.
Steam iron (K1) (optional)
Special accessory, see page 26 for the or-
der number.
Firmly insert the steam plug (K5) into
the appliance connector (A1). The locks
of the steam plug must lock into the co-
ver of the appliance connector.
Steam ironing
We recommend the use of the Kärcher
ironing table with active steam extraction.
This ironing table has been especially desi-
Figure 10