b-intense MED Bedienungsanleitung Seite 62

EN
The b-intense MED are intended for use in the electromagnetic environment specified below. The customer or the user of the b-intense MED
should assure that they are used in such an environment.
Immunity test Test Condition
Electrical fast ± 2 kV
transient/bursts 100kHz Repetition frequency
IEC 610004-4
Surges ± 0,5kV, ±1 kV line(s) to line(s)
IEC 61000-4-5 ± 0,5kV, ±1 kV, ± 2 kV line(s) to ground
(a)
Conducted RF 3 Vrms
induced by RF 150 kHz - 80 MHz
fields 6 Vrms ISM Bands c)
IEC 61000-4-6 80% AM 1kHz
Voltage dips, short 0 % UT;
interruptions and 0°,45°,90°,135°,180°,225°,270°,31
voltage variations 5°
on power supply
input lines 0 % UT;
IEC 61000-4-11 0°
0 % UT;
70 %
0 % UT;
0 %
Comment:
a) Not applicable to CLASS II ME EQUIPMENT and ME SYSTEMS.
b) The ISM (industrial, scientific and medical) bands between 0,15 MHz and 80 MHz are 6,765 MHz to 6,795 MHz; 13,553 MHz to 13,567 MHz; 26,957
MHz to 27,283 MHz; and 40,66 MHz to 40,70 MHz. The amateur radio bands between 0,15 MHz and 80 MHz are 1,8 MHz to 2,0 MHz, 3,5 MHz to 4,0
MHz, 5,3 MHz to 5,4 MHz, 7 MHz to 7,3 MHz, 10,1 MHz to 10,15 MHz, 14 MHz to 14,2 MHz, 18,07 MHz to 18,17 MHz, 21,0 MHz to 21,4 MHz, 24,89
MHz to 24,99 MHz, 28,0 MHz to 29,7 MHz and 50,0 MHz to 54,0 MHz.
Input a.c. power Port
IEC 60601
Compliance level
± 2 kV
± 1 kV Differential mode
± 2 kV Common mode
3 Vrms
150 kHz - 80 MHz
6 Vrms ISM Bands c)
80 % AM 1 kHz
0,5 Cycles
1Cycle
25/30 Cycles (50/60 Hz)
250/300 Cycles
(50/60 Hz) (5s)
62 62
Electromagnetic environment - guidance
Mains power quality should be that of a professi-
onal healthcare facility environment.
Mains power quality should be that of a professi-
onal healthcare facility environment.
Mains power quality should be that of a professi-
onal healthcare facility environment.
Mains power quality should be that of a professi-
onal healthcare facility environment.
If the user of b-intense MED requires continued
operation during power mains interruptions, it is
recommended that the b-intense MED are po-
wered from an uninterruptible power supply or
battery.