b-intense MED Bedienungsanleitung Seite 44

EN
General safety guidelines and use of the b-intense
› Read the Operation Manual thoroughly including the medical acvide.
› Don't use the b-intense
› Always check the b-intense
› Ensure the conformity of the electric connection with the specification on the nameplate.
› Ensure the proper connection and inspection of the shockproof socket,
› Ensure the proper protection and connection to a fault-current circuit breaker (FI) of the socket.
› Do not install the b-intense
› Never cover the infrared heaters!
› Keep easily flammable substances and fluids away from the infrared heaters.
› Don't leave the b-intense
› In case of visual damage of the cabin contact b-intense
› Never open the electrical components of the b-intense
› In case of damage on the supply cable disconnect the b-intense
› Don't modify or adapt the b-intense
› Exchange electronic components solely with original components of the manufacturer. All repairs must be performed by a qualified
engineer authorized by b-intense
Notes for safe use
› Use the b-intense
› The b-intense MED must be used with naked, at the start dry back.
®
› The b-intense MED MUST NOT be used without headrest and backrest.
®
› Open wounds, scars etc. must be covered.
› The surrounding temperature should not be lower than 18 °C during application.
› Preheat the b-intense
› Adjust the neck support so the back of your head rests centrally.
› Use less intensity (max. 50%) in the back heater in the beginning of the application for at least 5 minutes.
› Raise the intensity of the back heater after heating up in small measures (5–10% per 5 minutes), so you always feel a pleasant warmth
in the back.
› Reduce the intensity of the back heater for the last 5–10 minutes of application about 10% per 2 minutes.
› Enable enough air circulation between the back and the heater.
› Be careful not to touch the surface of the heater with your back.
› Watch out for a burning or painful feeling in the exposed area. Reduce the intensity if necessary.
› The b-intense MED is not intended for face application. Ensure to keep a safe distance to the front heater and do not look directly into
®
the heater for more than 9 minutes. Use safety glasses if necessary (at least protection level 4-4 according to EN171).
› Always use a towel for sitting.
› Desinfect all areas which are in direct contact with the body according to the instructions after every application.
› Clean the cabin regularly according to the instructions.
› NEVER cover the infrared heaters or their ventilation system.
Pay attention to all safety notices and application notes for your own safety!
Warning
In case of any disturbances, damages or injuries prior to, during or after application, immediately report to b-intense
ambiguities please contact us at office@b-intense.at.
MED without supervision.
®
MED for visual damage.
®
® MED in wet rooms, only in dry rooms (no condensing humidity).
MED operating unsupervised.
®
® MED!
. The electrical components must not be opened.
®
MED according to the intended purpose defined in the operation manual.
®
® MED to 25–28 °C for ideal results.
MED
®
.
®
® MED.
MED from the power supply and contact b-intense
®
44 44
® .
. For any questions or
®