Milltronics Pointek ULS200 Schnellstartanleitung Seite 6

All manuals and user guides at all-guides.com
Electronics/Enclosure
• termination:
• material:
• OR
• epoxy coated aluminum with gasket
• ingress protection:
• cable inlet:
Transducer
• material:
• mounting:
Approvals
• CE (EMC performance available upon request.), CSA
• CSA/FM Class I, Division 1, Group A, B, C, D; Class II, Group E, F, G; Class III
• ATEX II 2G, EEx md IIC T5
• C-TICK
• INMETRO: BR-Ex ia IIC T5
• SAA Ex ds Class I Zone 1; DIP Practice A Zone 21
(see product nameplate for approval details)
Installation
WARNINGS:
• Materials of construction are chosen based on their chemical compatibility (or
inertness) for general purposes. For exposure to specific environments, check with
chemical compatibility charts before installing.
• Explosion hazard. Substitution of components may impair suitability for Class I,
Division 2 applications.
• This product can only function properly and safely if it is correctly transported,
stored, installed, set up, operated, and maintained.
• The user is responsible for the selection of bolting and gasket materials which will
fall within the limits of the flange and its intended use, and which are suitable for
the service conditions.
Installation shall only be performed by qualified personnel and in accordance with
Note:
local governing regulations.
1.
Use only approved, suitable size hubs for watertight applications.
Page EN-4
terminal block, 2.5 mm
stranded, maximum
plastic
Type 6/NEMA 6/IP67
2 x ½" NPT or 2 x PG 13.5
ETFE or PVDF copolymer
threaded: 2" NPT, 2" BSPT, or 2" G
optional flange adapter, to 3" ASME, DIN 65PN10, and JIS
10K3B
Pointek ULS200 – QUICK START MANUAL
2
(14 AWG) solid 1.5 mm
1
, FM
US/C
2
(16 AWG)
7ML19981XB83