Milltronics Pointek ULS200 Schnellstartanleitung Seite 17

All manuals and user guides at all-guides.com
Range Limit
The range limit is the distance at which measurements are ignored. Generally this
refers to the bottom of the container being measured. If a measurement is
detected beyond the range limit it results in a Loss Of Echo (LOE) reading. The
result of this reading is determined by the Fail-Safe Mode, see page 16 for more
information.
Factory setting: 5.50 m (18.0 ft)
range
limit
0 to 3 m vessels (solids)
0 to 5 m (liquids)
Speed of Response
The speed of response adjustment allows the user to collectively set a number of
operating parameters.
measurement
response:
agitator
discrimination:
filter:
fail-safe timer:
SP measurement response
1 0.3 m / min (0.1 ft / min)
2* 1 m / min (3.3. ft / min)
3 5 m / min (16.4 ft / min)
4
* Factory setting
7ML19981XB83
is the limit to which the Pointek ULS200 is able to keep up with
rates of change.
If the Pointek ULS200 measurement cannot keep up with the
rate of level change, set the adjustment from 1 to 2.
If the Pointek ULS200 still cannot keep up with the rate of
level change, set the adjustment option to 3. Avoid
choosing an option that is too fast for your application.
discriminates between agitator blades in motion
and the material (target) surface.
discriminates between false echoes from acoustical
and electrical noise and the material (target) surface.
establishes the `Waiting' period from the time a loss
of echo or operating fault condition starts until the
fail-safe default is effected.
immediate
Pointek ULS200 – QUICK START MANUAL
range
limit
greater than 3 m vessels (solids)
greater than 5 m (liquids)
agitator
filter FLS timer
discrimination
on on
on on
on on
off off
10 min
10 min
3 min
3 min
Page EN-15