Press; Pump Up Control With Low Level Alarm; Pump Up Control With High Level Alarm - Milltronics Pointek ULS200 Schnellstartanleitung

All manuals and user guides at all-guides.com
Pump Control with Level Alarm
This application uses the Pointek ULS200 to provide pump control and one level alarm.
If the material reaches a control setpoint, the well is pumped down or up respectively. If the
material reaches an alarm setpoint, the alarm will sound until the material moves beyond the
deadband value.
Relay Function 8: Pump Up Control
with Low Alarm
relay 1
(pump up)
(eg. 3 m)
deadband 1
(eg. 2 m)
relay 2
(low alarm)
(eg. 3.5 m)
deadband 2
(eg. 1 m)
Operating Adjustments
To access the operating adjustments,
simultaneously press both keys repeatedly
until the desired adjustment is obtained. A
viewing period of the adjustment value is
initiated. During this time the value can be
changed by pressing either the `up' or
`down' key. After viewing or changing,
operation automatically reverts to the run
mode.
To adjust a value:
1. Press both operating buttons
select adjustment (eg. relay 1)
2.

Press 1 /

↑
change value (eg. increase to 0.75 m)
Page EN-12
Application Adjustments
relay function
blanking
(eg. 0.5 m)
alarm setpoint
pump off
alarm off
pump on
alarm on
current value (eg. 0.5 m)
new value (eg. new setpoint 0.75 m)
Pointek ULS200 – QUICK START MANUAL
6 - high control / low alarm
7 - high control / high alarm
8 - low control / low alarm
9 - low control / high alarm
10 - high control / LOE alarm
11 - low control / LOE alarm
set the low alarm to the desired
values
Deadband 2
Blanking
Deadband 1
Delay
Relay 2
Fail-safe timer
Relay 1
Relay function
after 6 sec. delay, return to run mode
Range limit
Speed of response
Fail-safe
Units
7ML19981XB83