Cutting Equipment - Husqvarna 215iL Bedienungsanweisung

Introduction on page 5 to find where
under the heading
these parts are located on your product.
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING:
defective safety components. The product's
safety equipment must be inspected and
maintained as described in this section. If
your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION:
on the machine requires special training.
This is especially true of the machine's
safety equipment. If your machine fails any
of the checks described below you must
contact your service agent. When you buy
any of our products we guarantee the
availability of professional repairs and
service. If the retailer who sells your
machine is not a servicing dealer, ask him
for the address of your nearest service
agent.
To do a check of the keypad
1. Press and hold the start/stop button (A). (Fig. 22)
a) The product is on when the LED (B) is on.
b) The product is off when the LED (B) is off.
Keypad on page 15 if the warning indicator
2. Refer to
(C) comes on or flashes.
To do a check of the power trigger lockout
The power trigger lockout prevents accidental start.
When you push the power trigger lockout (A), it releases
the power trigger (B). When you release the handle, the
power trigger and the power trigger lockout move back
to their initial positions.
(Fig. 23)
1. Make sure that the power trigger is locked when the
power trigger lockout is in its initial position. (Fig. 24)
2. Push the power trigger and make sure that it moves
back to its initial position when you release it. (Fig.
25)
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
spring works correctly. (Fig. 26)
4. Start the product. Refer to
page 13 .
5. Apply full power.
6. Release the power trigger and make sure that the
cutting attachment stops fully.
10
Never use a product with
All servicing and repair work
To start the product on
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Always use the recommended cutting
attachment guard for the cutting attachment
that you use, see
16 . If an incorrect or faulty cutting
attachment guard is attached, it can cause
serious personal injury.
The cutting attachment guard stops objects that eject in
the direction of the operator. The cutting attachment
guard also prevents injuries that can occur if you touch
the cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.

Cutting equipment

Select correct cutting equipment and do maintenance on
the cutting equipment to:
• Get maximum cutting performance.
• Increase lifetime of the cutting equipment.
WARNING:
attachments with the guards we
recommend! See
16 . Refer to the instructions for the cutting
attachment to find the correct way to load
the trimmer line and the correct trimmer line
diameter.
WARNING:
attachment may increase the risk of
accidents.
WARNING:
before you do the work on the cutting
attachment. This continues to rotate after
you release the throttle. Make sure that the
cutting attachment has stopped fully and
disconnect the spark plug cap before you
start the work on it.
Trimmer head
WARNING:
trimmer line is wound tightly and evenly
around the drum to prevent harmful
vibration.
(Fig. 27)
Do not use a cutting
Technical data on page
Only use cutting
Technical data on page
A defective cutting
Always stop the engine
Always make sure the
1737 - 001 - 27.10.2021