Set-Up And Commissioning; Setting Up The Battery Crimping Tool; Installation / Exchange Of Battery - HARTING 09 99 000 0990 Betriebsanleitung

HARTING Battery crimping tool 09 99 000 0990
8. Set up and commissioning
This chapter describes the initial commissio-
ning process for the crimping tool, the crim-
ping itself as well as setup changes e.g. of
locator and battery. Before using the tool for

8.1 Setting up the battery crimping tool

Before setting up the crimping tool, the fol-
lowing warning message must be observed:
WARNING!
②
14
the first time, you must have read and under-
stood these instructions as well as the Gene-
ral Safety Instructions (➱ Chapter 4.4.)
Risk of crushing fingers when inserting or removing
battery.
You risk crushing your fingers if your hands get into the area
between the receptacle and the contours of the battery while
detaching or attaching it. Therefore, hold the battery from the
sides so that fingers cannot be crushed.

8.1.1 Installation / exchange of battery

1. Check the charge level of the tool. If it
①
2. Press the battery module lock button on
③
3. Now, move the battery module in the di-
is too low (per activated green light, the
charge is +25% of the full charge), re-
charge the battery or use a replacement
battery.
the base of the crimping tool ②.
rection of the arrow ③ until it is released
from the base of the crimping tool.
HARTING Electric GmbH & Co. KG