HARTING
Electronics GmbH
D-32339 Espelkamp
HARTING
HARTING Crimp Tool D-Sub
for bandoliered contacts (500 contacts)
Part-No.: 09 99 000 0169
Crimping
Step 1
Open crimping tool.
Step 2
Make sure that the contact is at the center of the crimp profile af-
ter being pushed forward.
HARTING Electronics GmbH - V1.2 – 20-05 - Irrtum und Änderungen vorbehalten
ENGLISH
Step 3
Bring the crimping tool into the locked position (1-2 clicks).
Step 4
Push the stripped conductor into the contact.
Step 5
Close the hand tool completely until the safety ratchet enables the
tool to be opened.
Step 6
Remove crimped contact.
Care and Maintenance
Possibly, remove existing material and dirt residues, clean crimp
zone. Check the tool for correct closing of the profiles, clean mov-
ing parts and lightly oil it (machine oil SAE 20).
Clean after 75 crimping.
Crimp check after 1,100 crimping.
Maintenance after 7,000 crimping or 3 years.
•
Use only for crimping!
•
Only HARTING crimp contacts can be processed with the tool!
•
Protect the tool from dust and moisture!
If damage is found, only have the repair carried out by author-
ized specialist personnel!